BASS AMPLIFIER
The Electronic Tuner:
16. ELECTRONICTUNER (top panel):This active electronic tuner is on when-
ever the amplifier is turned on, allowing you constant, Oreal-time� tuning. The tuner
is fully chromatic � use the flat and sharp indicators until the LED between them
illuminates, indicating proper tuning.
The Rear Panel:
17. ACLINE CORD (rear panel, not shown):This heavy duty, grounded, three
wire power cord is to be plugged into a safely-wired, grounded, 120 volt, 60 cycle
AC power outlet. DONOT attempt to defeat the ground connection of this cable!
If your amplifier was purchased outside of the United States, see the unitOs rear
panel for its power and voltage ratings and follow the above guidelines.
18. FOOTSWITCH (rear panel, not shown):Connect the supplied two-button
footswitch here for remote control of the channel selection/Oblend� (see #5�) and
octave on/off. (When the Channel Switch [#5] is set to the Clean/B channel, the
footswitch switches between the Clean/B channel and the Distortion/Achannel;
when the switch is set to the Distortion/Achannel, the Clean/B channel is always
active, and the footswitch turns the Distortion/Achannel on and off, allowing you
a blend of both channels.)
19. EXTERNALSPEAKER (rear panel, not shown):Use this jack to connect the
amplifier to an external speaker cabinet (BX25DLX = 4W minimum, BX50DLX =
8W minimum). The internal speaker is disconnected when the external speaker
jack is used.
5 |