CA6110D Acoustic Amplifier
The Rear Panel:
1617181920212223 2425
16: Power. Use this switch to turn the amplifier on (top of the switch1.With footswitch button #3Os LED illuminated, select one of the DSP
depressed) and off (bottom of the switch depressed.) The powersettings
switch illuminates when the amplifier is on.2.Step on footswitch button #3 - the LED will go out - select a differ-
17: External Speaker. Use this jack to connect the amplifier to an externalent DSP setting
speaker cabinet. This jack is wired in series with the internal speakers3.Step on footswitch button #3 again - the LED illuminates, and the
which remain active when an external speaker is connected.DSP automatically changes back to the setting chosen in step 1.
18: Feedback Filters Footswitch. Connect the three-button footswitch to4.Step on footswitch button #3 again - the LED goes out, and the DSP
this jack for remote control of the feedback filters. The Feedbackautomatically changes back to the setting chosen in step 2.
Filters ON LED (#12, front panel) illuminates and the feedback circuit20: Effects Aux In/Eff Ret. When using an external signal processor or any
is activated when a footswitch is connected to this jack. Footswitchline level signal (drum machine, keyboard, etc), connect the output of the
button #1 controls Feedback Filter 1, button #2 controls Filter #2. (Seedevice to this jack by means of a shielded signal cable.
illustration below.)21: Effects Send. When using an external signal processor, connect this
Note: This is a STEREO jack: tip = Filter 1, ring = Filter 2, sleeve isjack to the input of the effect by means of a shielded signal cable.
ground. Use only a footswitch equipped with a stereo1/4� plug.22: Line Out Level. Use this control to adjust the output level of the line
19: DSP A/B Bank Footswitch. Connect the three-button footswitch toout signal. (This control works independently from the amplifierOs
this jack for remote control of twoDSP settings: master level control.)
23: High Z Bal Line Out. Use this jack to connect a high impedance, line
level signal to a house sound board, a recording console or an exter-
nal power amplifier by means of an 1/4� stereo plug-terminated
CA6110D Rear Panel:
cable. (Ring is signal +, tip is signal -, and sleeve is ground.) NOTE:The Feedback
circuit is activated24: Gnd Lift. This switch, when depressed, electronically disconnects
when a footswitch is
plugged into theboth of the Line Out jacksO (#23, #25) chassis ground connections. If
Feedback Filters
you experience excessive noise when using the Line Out jacks,Footswitch jack ---->
depress this switch.
25: Low Z Bal Line Out. Use this jack to connect a low impedance, line
level signal to a house sound board, a recording console or an exter-
112233
nal power amplifier by means of an XLR-terminated cable. (Pin 1 is
ground, pin 2 is signal +, and pin 3 is signal -.)
26: AC Line Cord (not shown). The grounded power cord should only
be plugged into a grounded power outlet that meets all applicable
Button #1:Button #2:Button #3:
TurnsTurnsToggeselectrical codes and is compatible with the voltage, power and fre-
quency requirements stated on the rear panel. Do not attempt toFeedbackFeedbackbetween
Filter #1Filter #2DSP
on and offon and offsettingsdefeat the safety ground connection!
5 |