GFX2200HT GUITAR AMPLIFIER
The Digital Signal Processor:
CrateOs Digital Signal Processing (DSP) offers 16 exciting digital effects, accessible through the DSP
Mode control. The effects are described as follows:
1REV 1small room reverb
2REV 2medium room reverb
3REV 3large room reverb
4REV 4concert hall reverb
LYLYCHO 1CHO 1
5DLY 1short slapback + small room reverbCHO 2CHO 2
6DLY 2medium delay + plate reverbRTRTRYRY
OCTVOCTV
7DLY 3long delay + large room reverbREVREV N N
T-T-WWAAHH
8FLNG 1slow deep flange + reverbI-WI-WAHAHBLRBLR
9FLNG 2flange + reverb + delayLEVEL
10CHO 1slow tremolo chorus + reverb
11CHO 2chorus + reverb + delay
Use the DSP Mode control to access
12RTRYsimulated rotating speaker effect
any of the 16 built-in digital effects.
13OCTV DNadds a signal one octave lower than input
Use the level control to mix in the
14T-WAHtouch sensitive wah-wah effectdesired amount of each effect.
15I-WAHinverse wah-wah effect
16DBLRsimulated second track, slightly out-of-sync
Channel Tracking:
Your Crate GFX2200HT gives you the power of Channel Tracking! Once you select a DSP setting for
each channel, Channel Tracking recalls those DSP settings automatically � without changing the DSP controls!
For example:
Y Select the Clean channel. Set the DSP Mode to OFLNG 1� (slow flange + reverb)
Y Select the Overdrive channel, Gain 1. Set the DSP Mode to OCHO 1� (slow chorus + reverb)(the setting for
the Clean channel is now saved to memory)
Y Select the Overdrive channel, Gain 2. Set the DSP Mode to OT(touch wah-wah)-WAH� (the setting for the
Overdrive channel, Gain 1 is now saved to memory)
Y Reselect the Clean channel (the setting for the Overdrive channel, Gain 2 is now saved to memory)
Now when you go back to the Clean channel, even though the DSP Mode was last set to OT-WAH,� Channel
Tracking automatically recalls the last setting for the Clean channel � in this example, OFLNG 1.� Change to the
Overdrive channel, Gain 1, and OCHO 1� is recalled. Change to the Overdrive channel, Gain 2, and OT-WAH� is
recalled. ThatOs the power of Channel Tracking!
(Note: Even when the power is turned ofChannel Tf, rackingstill retains the settings � until you change them!)
3 |
ACEC
